crwdns2915892:0crwdne2915892:0
How to re-calibrate the Yoke, in case the Pitch and Roll Axis, Mini-stick and/or throttle levers are not providing correct input
This calibration can be performed on PC and on Xbox.
-
-
If you have your Yoke plugged-in, then unplug it.
-
-
-
Set the switch at the back of the Yoke to PC position.
-
Don't forget to switch it back to Xbox, once you have completed this guide.
-
-
-
Make sure that Roll and Pitch are at resting point.
-
Make sure the right mini-stick is at resting point.
-
Make sure that Throttles are in the middle
-
-
-
Press and hold the buttons highlighted in the image
-
-
-
Connect the Yoke to USB port while holding the buttons.
-
Once the Xbox button starts flashing, release the buttons.
-
-
-
Press on the Xbox button.
-
It should start flashing faster.
-
-
-
-
Move the Yoke to the right, until you reach maximum.
-
Return the Yoke to Center.
-
-
-
Move the Yoke to the left, until you reach maximum.
-
Return the Yoke to Center.
-
-
-
Push the Yoke forward, until you reach maximum.
-
Return the Yoke to Center.
-
-
-
Pull the Yoke towards yourself, until you reach maximum.
-
Return the Yoke to Center.
-
-
-
Move the mini-stick to the right, until you reach maximum.
-
Return the mini-stick to Center.
-
-
-
Move the mini-stick to the left, until you reach maximum.
-
Return the mini-stick to Center.
-
-
-
Move the mini-stick up, until you reach maximum.
-
Return the mini-stick to Center.
-
-
-
Move the mini-stick down, until you reach maximum.
-
Return the mini-stick to Center.
-
-
-
Move both throttles down, until you reach maximum.
-
-
-
Move both throttles up, until you reach maximum.
-
-
-
Press Xbox button to finish the calibration.
-
Xbox button should stop flashing.
-
