crwdns2915892:0crwdne2915892:0
This guide will demonstrate how to replace your devices Fans. This guide is quick and simple. It will only take you 15-20 min and only uses a few tools. You might need to replace your devices fans if you can't hear them and your device is getting hot.
If the fans are spinning under load, use an ESD-safe brush to clean out the blades and remove any built-up debris.
crwdns2942213:0crwdne2942213:0
-
crwdns2935267:0crwdne2935267:0Tweezers$4.99
-
Remove the rubber cosmetic strip along the outside edge of the back plate with tweezers.
-
-
-
Remove the two rubber feet on the lower case with an opening tool.
-
-
-
Remove the two screws with a T3 Torx screwdriver.
-
-
-
-
Remove the seven screws securing the lower case with a T3 Torx screwdriver.
-
-
-
Lift the lower case gently and set it above the device.
-
-
-
Disconnect the battery cable by lifting the pull tab until it "clicks."
-
-
-
Remove the screws securing both of the fans with a T3 Torx screwdriver.
-
-
-
Flip up the ZIF locking flap on each socket.
-
Disconnect the ribbon cables attached to each fan.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
Western Carolina University, Team 1-3, Virtue Spring 2023 crwdns2935289:0Western Carolina University, Team 1-3, Virtue Spring 2023crwdne2935289:0
WCU-VIRTUE-S23S1G3
crwdns2931471:04crwdne2931471:0
crwdns2935297:013crwdne2935297:0
crwdns2947412:05crwdne2947412:0
Any idea where to buy the parts?
Any luck in getting the fan replacement part?
Same question, where I can buy those cover plastic stuff.
I am also looking for the fan parts
Hi, i am looking also for fan parts. If anybody knows, that would be awesome!
