crwdns2915892:0crwdne2915892:0
When games have been in storage or used for years on end, they need to get a good dose of TLC. In extreme cases you need to crack them open to get everything. It can be tense opening up a loved game in the fear that you'll destroy it.
Alternatively, you can open up a game no one liked and make it into an innocuous enclosure for something else.
crwdns2942213:0crwdne2942213:0
-
-
-
On the bottom front corners of the cartridge you should see two screws using the 3.8mm "Gamebit" screwdriver bit. A 3.0U Spanner bit can also get them out.
-
Once the screws are out, slide the front part of the plastic casing down to clear the tabs on the top of the case.
-
The two halves of the case should open easily.
crwdns2952109:0crwdne2952109:0
-
-
-
-
At this point the game board and pins are freely accessible.
-
Here you can fully clean the pin set and inspect for damage to the circuit board.
-
Cleaning the pins is the easiest part; use a cotton swab and either a rich mixture isopropyl alcohol or Brasso. Other people swear by an eraser(the white kind), but it can lead to damage if you're not careful. Personally, Brasso works the best.
-
-
-
Games with battery backup (allowing for save games to be stored in SRAM) allow access to the battery at this point for replacement. Most of the time the battery is a button cell: CR2032.
-
-
To reassemble the cartridge, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:023crwdne2935229:0
crwdns2947410:01crwdne2947410:0
Nintendo fix talk Nancy Places Nick III Fix SNES Alive Green
nj8324805 - crwdns2934203:0crwdne2934203:0 crwdns2950251:0crwdne2950251:0
