crwdns2915892:0crwdne2915892:0
If your Summer LookOut Duo baby monitor cameras are having trouble staying in position or they broke, then you may need to replace the stand. This step-by-step guide goes through how to replace the stand of baby monitor cameras.
Before proceeding, make sure the device is powered off and dry to avoid internal damage to the device or potential shock hazards.
CHOKING HAZARD: This device contains small screws. If possible, use a magnetic mat or small container within eyesight to keep track of the screws to prevent possible ingestion or misplacement.
crwdns2942213:0crwdne2942213:0
-
-
Remove the plastic wall mount attached to the base of the stand.
-
Remove the four 9 mm screws on the back four corners of the camera using a Phillips #00 screwdriver.
-
Remove the two 8 mm screws near the bottom center of the back of the camera using a Phillips #00 screwdriver.
-
-
-
-
Gently remove the front casing.
-
Grab the base of the stand and rotate it 90 degrees so the head of the stand is perpendicular to the opening. Tilt the head down and pull it through the opening.
-
Replace the new stand.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.