crwdns2915892:0crwdne2915892:0
The ready light is a simple LED that shows when the Barista has heated up to its needed temperature. This LED may burn out or its connectors may loosen.
crwdns2860944:0crwdne2860944:0
crwdns2860947:0crwdne2860947:0
crwdns2890040:0crwdne2890040:0
-
-
Unscrew the 6 screws from the back panel.
-
Remove the back panel.
-
-
-
-
Locate the ready light.
-
Gently push the fixture against the Barista wall.
-
Pull the fixture straight up to release it.
-
Note: The fixture works as a spring.
-
Note: The green cover from the front panel will "pop" off. Do not lose the green cover.
-
Disconnect the wire lead connectors.
-
Remove the ready light unit (fixture).
-
-
-
Replace the old LED with a new LED.
-
To put back, match the green cover to the slot of the LED fixture, then slide the fixture down against the barista wall.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2869486:0crwdne2869486:0
crwdns2878480:0crwdne2878480:0
crwdns2915084:0crwdne2915084:0
Cal Poly, Team 4-42, Regan Winter 2011 crwdns2886886:0Cal Poly, Team 4-42, Regan Winter 2011crwdne2886886:0
CPSU-REGAN-W11S4G42
crwdns2858115:04crwdne2858115:0
crwdns2886889:05crwdne2886889:0
crwdns2917036:04crwdne2917036:0
Beee2smoove.
Youth and sports for
Ttuii addinsists
Where can I get a new LED bulb?
