crwdns2915892:0crwdne2915892:0
Toys go through a lot, and many times they get dirty. This guide will show you how to remove the fur for further cleaning or full replacement.
crwdns2942213:0crwdne2942213:0
-
-
lay the Hatchimal on its side.
-
-
-
Using the plastic opening tool, push in on the purple clip.
-
-
-
Cut the fur retaining zip-tie with a pair of scissors.
-
-
-
-
Lift the fur up until it can't go further.
-
-
-
Use the spudger tool to push up on the black clip to free it.
-
Pull the clip out.
-
-
-
Lift fur up to reveal the next set of clips.
-
Insert a spudger to push up on the black clip to free it.
-
Pull out the clip.
-
-
-
Lift the fur up and over the Hatchimals Head.
-
Remove the six 12mm Phillips #00 screws from then body.
-
-
-
Pull the casing apart.
-
Remove the yellow speaker cable.
-
-
-
Remove the three 7mm Phillips #00 screws from the head.
-
Remove the wheel base and the circuit board carefully not to damage the spring.
-
-
-
Push the six black fur clips out using the spudger.
-
Remove the fur completely.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
USF Tampa, Team S1-G5, Nance Spring 2018 crwdns2935289:0USF Tampa, Team S1-G5, Nance Spring 2018crwdne2935289:0
USFT-NANCE-S18S1G5
crwdns2931471:03crwdne2931471:0
crwdns2935297:010crwdne2935297:0
