Spin Master Boxer Robot Screen Replacement
crwdns2944107:0crwdnd2944107:0Lauren Roidecrwdnd2944107:0crwdnd2944107:0crwdnd2944107:03crwdnd2944107:0crwdne2944107:0
crwdns2944111:0February 7, 2024crwdne2944111:0
crwdns2915892:0crwdne2915892:0
crwdns2942287:0crwdne2942287:0If Spin Master Boxer’s screen is cracked, follow this step by step guide to replace it. You will need a Size 00 Philips Screwdriver to complete guide.
crwdns2942213:0crwdne2942213:0
crwdns2943215:0crwdne2943215:0
-
-
Set Spin Master Boxer on your workspace so that the bottom panel faces upwards.
-
-
-
Using a Phillips #00 screw driver, unscrew the four 4mm screws in each corner of the bottom panel.
-
-
-
Carefully remove the bottom panel of the Spin Master Boxer by lifting up, away from the main body of robot.
-
-
-
While holding onto the axels of the wheels, gently pull the top panel of the robot away from its body.
-
-
-
Remove the plastic screen from the body of the robot. It should come off easily as it is not attached by anything.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0
crwdns2915084:0crwdne2915084:0
Cal Poly, Team S1-G1, Maness Spring 2019 crwdns2935289:0Cal Poly, Team S1-G1, Maness Spring 2019crwdne2935289:0
CPSU-MANESS-S19S1G1
crwdns2931471:04crwdne2931471:0
crwdns2935297:010crwdne2935297:0
