crwdns2915892:0crwdne2915892:0
This guide will replace the rear camera in the Sony Xperia Z1 Compact.
crwdns2942213:0crwdne2942213:0
-
-
Heat along the edges of the back cover using a heat gun to soften the glue.
-
-
-
Attach the small suction cup to the back cover near the bottom of the phone.
-
Pull up on the suction cup and insert the plastic opening tool in between the back cover and the rest of the phone.
-
-
-
Move the spudger around the edge of the back cover to separate it from the black adhesive.
-
-
-
Carefully disconnect the battery from the logic board by using the plastic spudger as a lever.
-
-
-
Remove the single 1 x 3.0 mm screw holding the battery in using the JIS #00 screwdriver.
The replacement batteries probably come without the new NFC sticker, so you’ll have to transfer it from the original one to the replacement. This can be easily done with an iPlastix and a good amount of isopropyl alcohol. Do this carefully.
-
-
-
Pry the battery up from the ends using the plastic spudger until the battery pops out of the enclosure.
-
-
-
-
Unscrew the four screws on the corners of the back frame using the JIS #00 screwdriver.
-
-
-
Wedge the plastic opening tool under the back frame. Move the plastic opening tool around the entire frame to separate it from the adhesive.
-
-
-
Wedge the spudger underneath the external speaker. Pull up on the external speaker using the spudger.
-
-
-
Remove the square rubber gasket from the camera using the plastic spudger.
-
-
-
Remove the black plastic corner still holding in the motherboard.
-
-
-
Carefully pry up on the four sides of the motherboard using the plastic spudger til it separates from the base of the phone.
-
-
-
Remove the motherboard from the device.
-
-
-
Disconnect the camera from the motherboard using a spudger.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0
crwdns2947410:01crwdne2947410:0
The trouble is that the headphones jack and the monitor cables are unplugged when removing the motherboard and I do not think it is possible to plug them back in from the back side of the phone. I think the monitor needs to be removed for them to be plugged from the front.