crwdns2915892:0crwdne2915892:0
You will need to use a source of heat. You may need to buy adhesive for the reassembly. Make sure the phone is completely powered off before opening the device.
crwdns2942213:0crwdne2942213:0
-
-
Apply heat on the back surface of the phone.
-
-
-
Stick the small suction cup on the bottom half of the back surface of the phone.
-
-
-
With the bottom of the device facing you, lift up on the suction cup handle.
-
Use the plastic opening tool around all sides to pry off the back cover.
-
-
-
Pull the back of the phone case away from the device.
-
-
-
Apply heat to the copper RAF antenna.
-
-
-
-
Pry up the copper connector next to the battery with the plastic opening tool.
-
-
-
Remove the five black 4mm screws with a Phillips #00 Screwdriver.
-
-
-
Pry up the black camera case with the plastic opening tool and then remove the case.
-
-
-
Pop off the small connector on the right side of the motherboard with the plastic opening tool.
-
-
-
Use the spudger to take off the connector in the top right of the motherboard.
-
-
-
Use the flat end of the spudger to peel up the copper tab to the right of the back camera.
-
Peel back the tab past the connector.
-
-
-
Pry up the camera's connector to the motherboard with the nylon spudger.
-
-
-
Use the spudger to loosen the black connector from the top right of the motherboard.
-
-
-
Pull out the square shaped connector using tweezers.
-
-
-
Use the spudger to detach the three copper connectors on the bottom area of the motherboard.
-
-
-
Use the spudger to separate the motherboard from the frame.
-
Pull out the motherboard using your fingers.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:02crwdne2935229:0