crwdns2915892:0crwdne2915892:0
You will need to use a source of heat. You may need to buy adhesive for the reassembly. Make sure the phone is completely powered off before opening the device.
crwdns2942213:0crwdne2942213:0
-
-
Apply heat on the back surface of the phone.
-
-
-
Stick the small suction cup on the bottom half of the back surface of the phone.
-
-
-
With the bottom of the device facing you, lift up on the suction cup handle.
-
Use the plastic opening tool around all sides to pry off the back cover.
-
-
-
Pull the back of the phone case away from the device.
-
-
-
-
Apply heat to the copper RAF antenna.
Where can i buy this copper raf antenna
I also need it for my phone I kinda ripped it apart oops ?
Tiybah -
Mike J - I found that simply raising the edge overlapping the battery connector gave sufficient room to disconnect the battery so no need to remove the antenna and risk tearing!
-
-
-
Peel back the RAF antenna.
I’ve ripped the copper part of this would I be able to get a new part or will the phone not work with out it?
-
-
-
Peel back the black tabs on the battery.
-
-
-
Use a plastic opening tool to pry up the orange battery connector that is directly above the battery in the center of the phone.
-
-
-
Use a plastic opening tool to get under the battery and pry it up.
-
-
-
Lift the battery out with your hands.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:011crwdne2935229:0
crwdns2915084:0crwdne2915084:0
Cal Poly, Team S17-G2, Livingston Spring 2018 crwdns2935289:0Cal Poly, Team S17-G2, Livingston Spring 2018crwdne2935289:0
CPSU-LIVINGSTON-S18S17G2
crwdns2931471:04crwdne2931471:0
crwdns2935297:08crwdne2935297:0
crwdns2947410:01crwdne2947410:0
Thanks for such a clear set of instructions. I used a hair drier rather than heat gun!
