crwdns2915892:0crwdne2915892:0
This guide will assist you in taking apart the phone to remove the circuit board as this is a required step in almost all of the part replacements for this camera.
crwdns2942213:0crwdne2942213:0
-
-
Place phone down with screen side down and camera side facing up as shown.
-
Push on cover away from you. You should hear a snap or pop. This will let you view the battery and sim/sd card slots. Then lift the cover off.
-
-
-
Locate and remove the five (5) screws on the phone, using a screwdriver. The screws are at the top and the bottom of the phone as shown.
-
-
-
Pry off the bottom white cover by using the opening tool as a lever.
-
-
-
Locate and remove the 2 additional screws, using the Torx screwdriver, that are revealed. These are marked as shown.
-
-
-
-
Locate the black cover on the bottom left of phone. Use an opening tool to pry up and remove the black cover.
-
-
crwdns2935267:0crwdne2935267:0Tweezers$4.99
-
Disconnect the circuit by lifting the connector straight up as shown using the tweezers.
-
-
-
Turn the phone onto its side, insert plastic opening tool into seam, and gently remove cover. You can also slide the spudger in from the top.
-
Once the cover is loose, lift it off the phone. The side buttons may feel a bit sticky, but this is normal.
-
-
-
Locate the additional circuit at the bottom left. Using the tweezers, remove it gently by pulling up.
-
-
-
Use the tweezers to lift up on the circuit located at the top left.
-
-
-
Use the spudger and slide it under the top left of the board then lift the board straight up. The board should come up very easily.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:05crwdne2935229:0
crwdns2947412:02crwdne2947412:0
Some of these pictures are too blurry.
You need written instructions for each step.