crwdns2915892:0crwdne2915892:0
This guide will take you through 6 simple steps to removing your circuit board. For reattachment, simply follow the steps in reverse order.
crwdns2942213:0crwdne2942213:0
-
-
Unscrew the two screws on the back of the device using a Phillips PH000 screwdriver.
-
-
-
Use a small prying tool to carefully pry open the back of the device.
-
-
-
-
First, you must remove the black tape on the circuit board.
-
Next, pull up on the red and gold band until it detaches from the chip.
-
-
crwdns2935267:0crwdne2935267:0Tweezers$4.99
-
Using a small plastic prying tool, slip the end under the device circuit board and slowly lift it.
-
Once the circuit board is lifted, carefully remove the chip with tweezers.
-
-
-
Using a soldering iron, carefully heat the metal connecting the wires from the device to the circuit board.
-
-
-
Carefully remove the circuit board from the device.
-
For reassembling your device, follow the instructions in reverse.
For reassembling your device, follow the instructions in reverse.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0
crwdns2915084:0crwdne2915084:0
Eastern Washington University, Team 2-5, Plummer Fall 2015 crwdns2935289:0Eastern Washington University, Team 2-5, Plummer Fall 2015crwdne2935289:0
EWU-PLUMMER-F15S2G5
crwdns2931471:04crwdne2931471:0
crwdns2935297:06crwdne2935297:0
