crwdns2915892:0crwdne2915892:0
Use this guide to remove a faulty Bluetooth component.
crwdns2942213:0crwdne2942213:0
-
-
To gain access to the 6 bottom screws remove the following. Remove the adhered 4 corner foam pads on the bottom of the speaker using the blue plastic opening tool to reveal the screws underneath. Remove the adhered 2 center plastic squares.
-
-
-
Unscrew the six 6mm screws with a Phillips head #1 screwdriver.
-
Remove the bottom panel of the speaker.
-
-
-
Unplug the battery by gently pinching the plastic end connected to the smaller board and pull away.
-
Remove the battery.
-
-
-
To remove the speaker grill, first push down slightly on the 2 plastic hook tabs to release them, then push the middle plastic screw tab out.
-
-
-
-
Remove the eight 0.5mm Phillips #1 screws from the speaker panel.
-
-
-
Using the plastic opening tool, flip open the speaker panel.
-
-
-
Unplug the 6-pin speaker connector and 2-pin microphone connector from the motherboard by squeezing the sides of the plastic ends.
-
-
-
Unplug the cord connected to the motherboard by squeezing the plastic sides.
-
-
-
Gently tug on the plastic ribbon connected to the bottom side of the speaker to unplug it.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:02crwdne2935229:0
crwdns2915084:0crwdne2915084:0
Eastern Washington University, Team 2-6, Mathisen Fall 2016 crwdns2935289:0Eastern Washington University, Team 2-6, Mathisen Fall 2016crwdne2935289:0
EWU-MATHISEN-F16S2G6
crwdns2931471:04crwdne2931471:0
crwdns2935297:05crwdne2935297:0
crwdns2917034:0crwdne2917034:0
Muy bueno! Gracias Jeffrey!.
