crwdns2915892:0crwdne2915892:0
Can't listen to recording with scratchy or without sound! Follow this speaker replacement guide to once again be able to listen those recordings.
crwdns2942213:0crwdne2942213:0
-
-
Undo hand strap.
-
Get iFixit screwdriver and a JIOS Philips head bit.
-
-
-
Place device on left side with lens facing right.
-
Using the screwdriver, unscrew the left middle screw.
-
Open the "DC IN" tab.
-
Unscrew this screw.
-
-
-
Turn device onto it's top with the lens facing right.
-
Unscrew the top left and top right screws.
-
-
-
Remove the right side casing by pulling away.
-
-
-
Using your fingers, lift the HDD by it's right end, pivoting on it's left end.
-
-
-
Using your fingers, pull the ribbon wire out of it's socket.
-
-
-
-
Using your fingers, remove the A/V tab.
-
-
-
On the bottom of the device, unscrew the right and middle bottom 3mm Philips screws.
-
Remove panel.
-
-
-
Using the screwdriver, unscrew the top two black 3mm Philips screws.
-
Lift out the grey tray, being careful when feeding the large ribbon wire though the slot.
-
-
-
Using the black pointed spudger, carefully pop op the latch on the large ribbon wire's port.
-
Set large ribbon wire aside.
-
-
crwdns2935267:0crwdne2935267:0Tweezers$4.99
-
Using the blunt tweezers, unplug the red and black wires.
-
Using the blunt tweezers, unplug the small ribbon wire.
-
-
-
Unscrew the top 3 3mm Philips screws from right to left.
-
-
-
On the back of the device, unscrew the top 3mm Philips screw.
-
-
-
On the left side of the device, unscrew the top 2 3mm Philips screws.
-
-
-
Remove the top of the device by lifting it upwards.
-
-
-
With the top of the device in hand, remove the 4 visible 3mm Philips screws.
-
Remove the frame by lifting away.
-
-
-
Remove the broken speaker with your fingers.
-
Replace with new speaker.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.