crwdns2915892:0crwdne2915892:0
This guide shows how to remove the Screens.
crwdns2942213:0crwdne2942213:0
-
-
To remove the back cover, use your thumb to press down on the center of case and slide it off.
-
-
-
Using a fingernail lift the battery out of the phone.
-
-
-
To remove the front cover, lift up the case with a fingernail in the small slot as shown.
-
-
-
To remove the front grey case, remove the two screws shown with a T5 Torx Screwdriver.
-
-
-
-
Pry up the dark grey case with your fingernail until all four snaps around the top are loose.
-
-
-
Lift up towards the bottom and slide the case off.
-
-
-
Use a plastic opening tool to lift the black tape off of the ribbon cable connector.
-
-
-
Lift the ribbon cable connector lock using a plastic opening tool.
-
-
-
Slide the black ribbon cable tray out with a plastic opening tool.
-
Shown in the second picture is the try already slid out.
-
-
-
Slide the ribbon cable out of the connector.
-
Shown in the second picture is the cable already out.
-
-
-
Use a plastic opening tool to lift up on the screen board and release the clips holding it in place.
-
Lift the entire board out of the phone to remove both screens.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
Cal Poly, Team 5-15, Maness Fall 2010 crwdns2935289:0Cal Poly, Team 5-15, Maness Fall 2010crwdne2935289:0
CPSU-MANESS-F10S5G15
crwdns2931471:04crwdne2931471:0
crwdns2935297:026crwdne2935297:0
