crwdns2915892:0crwdne2915892:0
This guide will instruct you on how to replace a defective LCD screen in the Sony Cyber-shot DSC-W150. To successfully remove the screen a screwdriver is used to remove a screw, a spudger, and tweezers to remove electrical ribbons.
crwdns2942213:0crwdne2942213:0
-
-
Take your screwdriver and remove the four silver bottom screws of the camera.
-
-
-
On the right side of the camera, remove the two silver screws using the screwdriver.
-
-
-
On the left side of the camera, remove the two silver screws using the screwdriver.
-
-
-
Gently detach the back cover by holding onto both sides of the camera and pulling them apart.
-
-
-
After detaching the back cover, carefully pull it off.
-
-
-
The back cover should now be separated from the camera.
-
-
-
-
Remove the two screws at the top of the camera casing.
-
-
-
After removing the screws, gently pop open the plastic piece, as shown by firmly pulling it with your fingers.
-
-
-
After popping open the plastic piece, there is a screw that needs to be removed.
-
Remove the screw connecting the front casing to the electrical components.
-
-
-
On the casing on the opposite side of the camera, gently loosen and remove the casing by firmly pulling with your fingers.
-
-
-
Remove the two screws connecting the front casing to the electrical components using a screwdriver.
-
-
-
Gently loosen the front casing by gently using your fingers to pull it apart.
-
-
-
Fully remove the front casing from the camera and set it aside.
-
-
-
Using a screwdriver, remove the last screw holding the LCD/control panel to the rest of the camera on the right-hand side.
-
-
-
Paying careful attention to the right side's electrical wiring, gently pull the left side of the LCD plate away from the rest of the camera.
-
-
-
Using a spudger, wedge the flat-tipped end between the black bar and the circuit board.
-
Carefully lift the black bar into the vertical position.
-
-
-
Use tweezers to carefully pull the larger electrical ribbon from its circuit board port.
-
-
-
Use tweezers to pull the smaller electrical ribbon carefully from its circuit board port.
-
-
-
Desolder the small electrical ribbon that connects the control panel to the LCD screen.
-
Now the LCD/control panel is completely removed from the part and ready to be replaced.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:04crwdne2935229:0
crwdns2915084:0crwdne2915084:0
Cal Poly, Team 33-73, Johann Spring 2010 crwdns2935289:0Cal Poly, Team 33-73, Johann Spring 2010crwdne2935289:0
CPSU-JOHANN-S10S33G73
crwdns2931471:03crwdne2931471:0
crwdns2935297:02crwdne2935297:0
