crwdns2915892:0crwdne2915892:0
The LCD should be checked if the screen is blank or broken.
crwdns2942213:0crwdne2942213:0
-
-
Open the battery compartment and remove the batteries.
-
Remove all of the visible screws on the outside of the case.
-
-
-
Open the memory card compartment.
-
Remove the screw next to the memory card slot.
-
-
-
Pull apart the front and back cover pieces carefully.
-
-
-
Simultaneously unclip all of the clips holding in the circuitry. Remove the back case.
-
-
-
-
Unclip the clip holding the ribbon cable in.
-
-
-
Unclip the ribbon cable shown the in picture.
-
-
-
Remove 7 Screws to remove plate and expose LCD screen.
-
-
-
Remove LCD plate to expose LCD components and ribbon cables
-
-
-
Check connection of LCD to cables
-
If cables are intact, disconnect cables and replace LCD with new part
-
-
-
Repeat steps in reverse order to reassemble the camera
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
Cal Poly, Team 3-43, Regan Winter 2011 crwdns2935289:0Cal Poly, Team 3-43, Regan Winter 2011crwdne2935289:0
CPSU-REGAN-W11S3G43
crwdns2931471:04crwdne2931471:0
crwdns2935297:020crwdne2935297:0
crwdns2917034:0crwdne2917034:0
I don’t know the cause of my camera not turning on.
