crwdns2915892:0crwdne2915892:0
In order to reach the flash capacitor, you have to remove the front and back panel, the button board and the top cover of the device. Be very careful when you remove these parts.
crwdns2942213:0crwdne2942213:0
-
-
Slide the lock at the bottom of the camera to "Open".
-
-
-
Slide the blue clip up and away from the battery.
-
-
-
-
Remove the six 3.5mm Phillips #000 screws.
-
Rotate the lock away from the camera.
-
-
-
Pry the device open with the plastic opening tool.
-
-
-
Remove the two plastic spacers between the front and the back panels.
-
Carefully remove the back panel.
-
-
-
Gently release the button board from the clips.
-
-
-
Disconnect the no-fuss ribbon cable by gently pulling it out of the button board.
-
-
-
Lift the capacitor from the assembly.
-
Disconnect the no-fuss ribbon cable by gently pulling it out of the flash board.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.