crwdns2915892:0crwdne2915892:0
In order to reach the flashboard unit inside the device you have to first remove the front and back panel, the button board and the top cover of the device.
crwdns2942213:0crwdne2942213:0
-
-
Slide the lock at the bottom of the camera to "Open".
-
-
-
Slide the blue clip up and away from the battery.
-
-
-
Remove the six 3.5mm Phillips #000 screws.
-
Rotate the lock away from the camera.
-
-
-
-
Pry the device open with the plastic opening tool.
-
-
-
Remove the two plastic spacers between the front and the back panels.
-
Carefully remove the back panel.
-
-
-
Gently release the button board from the clips.
-
-
-
Disconnect the no-fuss ribbon cable by gently pulling it out of the button board.
-
-
-
Gently pry the flash board up from its clips.
-
-
-
Gently pull out the no-fuss ribbon cable from the flash board.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:02crwdne2935229:0