crwdns2942213:0crwdne2942213:0
-
-
Begin by placing the camera flat against a surface and remove the nine (9) black screws. Each screw is of the same length and can be used interchangeably
-
-
-
Use a plastic opening tool to carefully pry off the front casing.
-
-
-
Flip the camera over 180 degrees and similarly pry off the rear casing.
-
-
-
-
Once the outer casings have been removed, the silver side trim should come loose from the camera.
-
Place the camera with the lens facing down. Use the plastic opening tool to pry off the side panel with the USB plug.
-
-
-
Place the camera with the lens facing down. Use the phillips head screwdriver to remove the silver screw in the corner near the photo capture button.
-
Flip the camera over. Use the plastic opening tool to detach the black clip near the capture button.
-
Grasp the top cover and gently remove it from the camera body.
-
-
-
After the outer casing is removed, lay the device display side up
-
Gently pry the LCD screen from the body of the camera.
-
-
-
Flip the LCD Assembly around the edge of the camera
-
Use the plastic opening tool to gently pry up the black tab locking the large ribbon cable to the battery housing.
-
Grasp the LCD display with your fingers and gently pull the large ribbon cable out of the connector.
-
The LCD display is now detached from the camera.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
Clemson, Team 13-4, Benson Fall 2013 crwdns2935289:0Clemson, Team 13-4, Benson Fall 2013crwdne2935289:0
CLEM-BENSON-F13S13G4
crwdns2931471:03crwdne2931471:0
crwdns2935297:014crwdne2935297:0
crwdns2917034:0crwdne2917034:0
What LCD screen can i replace it with
