crwdns2915892:0crwdne2915892:0
This guide will help you to replace the top panel on the Sony Cyber Shot DSC-W170.
If the shutter button or the power button are not working properly, the solution is to replace the top panel unit. Be sure to remove power/disconnect batteries before performing this task!
Take a look at our troubleshooting page if you need help to remove the battery.
On the Sony website you can find replacement parts for the camera.
crwdns2942213:0crwdne2942213:0
-
-
Remove the five 4 mm screws with a Phillips #000 screwdriver.
-
-
-
Use an opening pick to pry the LCD panel open.
-
-
-
Gently remove the LCD panel from the rest of the camera.
-
-
-
Remove the three 4 mm screws with a Phillips #000 screwdriver.
-
-
-
Gently open the front panel and remove it from the rest of the camera.
-
-
-
Remove the first side panel to the left of the LCD.
-
Remove the 4 mm screw from the other side panel to the right of the LCD with a Phillips #000 screwdriver.
-
-
-
-
Gently, lift the LCD and carefully open the camera to disconnect the LCD ribbon cable from the motherboard.
-
-
-
Gently push the connector through the hole to separate the LCD from the metal casing.
-
-
-
Lift up the black bar on the top flat ribbon cable with tweezers.
-
Gently pull the flat ribbon cable until it disconnects from the lens assembly.
-
-
-
Remove the six 4 mm screws from the lens assembly with a Phillips #000 screwdriver.
-
-
-
Lift the two flat ribbon cables with tweezers.
-
-
-
Peel back the flash assembly on the back of the lens.
-
Remove the two 4 mm screws with a Phillips #000 screwdriver.
-
-
-
Pull out the battery from the side and remove the white tape from the battery assembly with tweezers.
-
-
-
Disconnect the flat ribbon cable that connects the motherboard to the lens assembly with tweezers.
-
-
-
Remove the 4 mm screw from the bottom side of the top panel with a Phillips #000 screwdriver.
-
-
-
Remove the silver 4 mm screw with a Phillips #000 screwdriver from the silver bracket connected to the motherboard.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
University of North Texas, Team 4-12, Harold Fall 2023 crwdns2935289:0University of North Texas, Team 4-12, Harold Fall 2023crwdne2935289:0
UNT-HAROLD-F23S4G12
crwdns2931471:03crwdne2931471:0
crwdns2935297:05crwdne2935297:0
