crwdns2915892:0crwdne2915892:0
The following guidelines will show the step-by-step procedure on how to remove and replace the Sony Clie thumb dial.
crwdns2942213:0crwdne2942213:0
-
-
First, place the device with the screen side facing down. Remove the 2 screws from the thumb dial panel located on the upper right hand side.
-
-
-
Remove the screw directly above the thumb dial panel.
-
-
-
Remove the screw from thumb dial panel on the right handed side of the device.
-
-
-
Remove screw from lower right side of the device.
-
-
-
-
Remove 1 screw from the lower left side of the device.
-
-
-
On the bottom of the device, remove both the left and right screws.
-
-
-
Remove the thumb dial panel by sliding it away from the device.
-
-
-
Remove the back panel exposing the inside of the device.
-
-
-
Locate thumb dial on top right side of the board.
-
-
-
Follow ribbon wire to locate where it plugs into the board. The plug is a flat black square.
-
-
-
Pull plug straight up to remove from board.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.