crwdns2915892:0crwdne2915892:0
Every battery runs out of power eventually after many uses. This guide will show you how to easily replace the battery on your Sonly Bloggie 3D.
crwdns2942213:0crwdne2942213:0
-
-
Remove the two 2.5mm Phillips #00 screws using the Philips #00 screwdriver.
-
-
-
Use a plastic opening tool to pry the cover open.
-
After the the cover is partly open as shown, remove the cover with your hands.
-
-
-
crwdns2935267:0crwdne2935267:0Tweezers$4.99
-
Using your hand, or a pair of tweezers, remove the ZIF connector by gently pulling it out of the dock on the circuit board.
-
-
-
Use a plastic opening tool to loosen the back cover off the device.
-
Once the back cover is loose, remove it gently by hand.
-
-
-
Remove the battery with your fingers.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2947410:01crwdne2947410:0
You forgot to mention the need to flip the screen up (a screw holds it down) in order to get to a screw holding the back cover. Other than that, thank you for the info.