crwdns2915892:0crwdne2915892:0
The control wheel is used to navigate through pictures, and can wear down over time, and will need replacement.
crwdns2942213:0crwdne2942213:0
-
-
Turn the camera off by sliding the power switch.
-
-
-
Use a Phillips head 000 screwdriver to remove the 4.0mm screw inside the USB port.
-
-
-
Use a Phillips head 000 screwdriver to remove the one 4.0mm screw on the side opposite of the USB port near the shutter button.
-
-
-
Open the flap at the top of the camera.
-
Use a Phillips head 000 screwdriver to remove the two 4.0mm screws inside.
-
-
-
-
Gently lift off the top panel with your hands.
-
-
-
Use a Phillips head 000 screwdriver to remove the 4.0mm screw at the side opposite of the USB port.
-
-
-
Use a Phillips head 000 screwdriver to remove the three 4.0mm screws on the bottom of the camera.
-
-
-
Tilt up the LCD screen.
-
Use a Phillips head 000 screwdriver to remove the two coarse 4.0mm screws near the bottom of the camera.
-
-
-
Gently pry off the back panel, by wiggling it around the LCD screen.
-
-
-
Tilt up the LCD screen.
-
Grab the silver plate, and gently pry it up.
-
-
-
Gently pinch blue ribbon cable, and pull it out of the port.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:03crwdne2935229:0