crwdns2915892:0crwdne2915892:0
This Guide shows how to replace the O-ring in the Sony AZ1VR Lens. Replacing a warn down O-ring on the lens provides improved water proofing. With this devices being a water proof action camera it is essential to keep the devices O-rings up-to-date. The materials required to do this repair are a Phillips-head screw driver and the new O-ring.
crwdns2942213:0crwdne2942213:0
-
-
Start by removing the two screws on the bottom, and the screw inside the battery room.
-
Once these are removed, slide the door out, and the small piece of plastic with the door.
-
-
-
-
Now, grab the lens and pull the body out of the plastic, this will reveal the insides of the device.
-
You'll see a screw on the top of the device, towards the front, remove this screw.
-
Next pull the tabs on the bottom and top of the lens, and pull outward, this will remove the lens housing from the body.
-
-
-
Next, you'll see a white ring around the lens, slowly remove that ring without causing damage to the device.
-
Now put the new one in its place. Now reassemble the device, it's all set to be used.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
UMass Dartmouth, Team S3-G5, Botvin Spring 2017 crwdns2935289:0UMass Dartmouth, Team S3-G5, Botvin Spring 2017crwdne2935289:0
UMASSD-BOTVIN-S17S3G5
crwdns2931471:03crwdne2931471:0
crwdns2935297:010crwdne2935297:0
