crwdns2915892:0crwdne2915892:0
Replacing all antennas on Sonos Play 5
crwdns2942213:0crwdne2942213:0
-
-
Disconnect any power to the speaker and wait a few minutes for the capacitors to fully discharge.
-
Flip the speaker upside down.
-
-
-
Remove eight 10mm Phillips #2 screws
-
Remove the bottom panel by pulling upwards.
-
-
-
Flip the device so that the grille is facing up.
-
Locate the line on the right side of the speaker where the grill and the plastic meet, and place your plastic opening tool in the gap.
-
Run the spudger along the gap, loosening the grille from the plastic. Repeat this process on the left side as well.
-
Gently pull up on the grille, removing it from the front panel.
-
-
-
Remove the six 8mm Phillips #2 screws.
-
Remove the two 10mm Phillips #2 screws.
-
-
-
Locate the line on the right side where the front panel and back panel meet. Place a plastic opening tool in the gap, and run it along the gap. Repeat this on the left side.
-
Use the opening tool to lift the front plate. If a plastic tool is not providing enough leverage, use a metal opening tool.
-
Gently pull up on the face plate to ensure it has been detached from the enclosure.
-
-
-
Lift up the front panel, forming a 90 degree angle with the back panel. Locate the locate ten pin connector shown. This is the wire that connects the front panel to back panel.
-
Press down on the small tab located on the connector. With the tab firmly pressed down, pull the connector out from its socket.
-
The faceplate assembly is now fully detached from the rest of the speaker.
-
-
-
Remove the ten pin connector.
-
-
-
-
Flip the device over on its front side.
-
-
-
Remove six 5mm Phillips #0 screws.
-
Remove two 7mm Phillips #2 screws.
-
-
-
Remove the grey and red antenna connectors by lifting them away from the board.
-
Pull cords away from the board.
-
-
-
Remove the yellow antenna connector by lifting it away from the board.
-
Pull cord away from the board.
-
-
-
Remove circuit board by lifting it straight away from the rear plate.
-
-
-
Flip device so that the bottom is facing upwards.
-
Identify the 3 antennas to be replaced.
-
-
-
Lift each board and hang over the side.
-
-
-
Remove first rubber strain relief by pinching the rubber then lifting up and away.
-
-
-
Remove second rubber strain relief by pinching the rubber then lifting up and away.
-
-
-
Remove third rubber strain relief by pinching the rubber then lifting up and away.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0
crwdns2915084:0crwdne2915084:0
USF Tampa, Team S3-G6, Sullivan Spring 2017 crwdns2935289:0USF Tampa, Team S3-G6, Sullivan Spring 2017crwdne2935289:0
USFT-SULLIVAN-S17S3G6
crwdns2931471:04crwdne2931471:0
crwdns2935297:016crwdne2935297:0
crwdns2947410:01crwdne2947410:0
Where do you buy the replacement antennas?
