crwdns2915892:0crwdne2915892:0
Traction pads are used to give you extra grip when you have one foot out of the bindings. This guide is about detaching and attaching traction pads.
crwdns2942213:0crwdne2942213:0
-
-
Use a plastic or metal scraper to remove the existing traction pad.
-
-
-
-
If there is any residual adhesive left from the old traction pad, soak it with adhesive remover.
-
Let the adhesive remover sit for a few minutes.
-
Wipe away the residue using a towel and water.
-
Dry the the surface where the new traction pad will be placed.
-
-
-
Peel the back off of the new traction pad to reveal the adhesive.
-
When placed, the traction pad should be about an inch away from the rear binding.
-
To avoid creating air bubbles, start with one corner of the pad and roll the rest down.
-
Press down firmly to help it stick to the board and remove any air bubbles that may have occurred.
-
Give the adhesive a minimum of 12 hours to dry before use.
-
crwdns2915084:0crwdne2915084:0
Cal Poly, Team 17-4, Forte Winter 2014 crwdns2935289:0Cal Poly, Team 17-4, Forte Winter 2014crwdne2935289:0
CPSU-FORTE-W14S17G4
crwdns2931471:05crwdne2931471:0
crwdns2935297:09crwdne2935297:0
