crwdns2942213:0crwdne2942213:0
-
-
Start by having the new snowboard binding and screws set aside. Make sure to also have a standard Phillips screwdriver.
-
-
-
First, align the screw and attach the plastic strip.
-
-
-
Then begin to tighten the plastic strip by using the screwdriver with one hand and then holding the nut with the other to tighten the plastic strip.
-
-
-
-
This is what it should look like so far.
-
-
-
Now we will begin to attach the strap to the opposite side. Like previously, you will need a screwdriver to tighten the strap once you have aligned the screw and attached the nut on the other side.
-
-
-
Make sure to not tighten it too much as the strap needs to be able to move slightly.
-
-
-
Once everything is tightened properly this is what it should look like. Congrats you have successfully repaired a snowboard binding!!!
-
-
-
Now it's time to take a picture with your fix!
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
