Smart Tweezers and LCR-Reader LCR-meter Screen Replacement
crwdns2944107:0crwdnd2944107:0brittanycrwdnd2944107:0crwdnd2944107:0crwdnd2944107:02crwdnd2944107:0crwdne2944107:0
crwdns2944111:0February 11, 2015crwdne2944111:0
crwdns2915892:0crwdne2915892:0
crwdns2942287:0crwdne2942287:0Before opening the LCR-Reader, place a small bit of tape over the button on the top housing. This will keep the button from falling loose and being lost.
crwdns2942213:0crwdne2942213:0
crwdns2943213:0crwdne2943213:0
crwdns2943215:0crwdne2943215:0
crwdns2944105:0crwdne2944105:0
-
-
Start by removing the 4 screws in the back of the device using a size 00 Philips screw driver.
-
-
-
Gently open the zif connector that holds the screen.
-
Insert the replacement screen, and close the zif
-
-
-
When closing the housing, make sure the screen fits into the rectangle on the top.
-
If the screen is not in this rectangle, it may become damaged when the screws are tightened
-
Hold the screen in place from below; line up the button's edge of the top housing to line up with the bottom housing. Slide your finger out as you bring the top and bottom housings to meet.
-
Replace the 4 Philips screws in the back.
-
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0
