crwdns2915892:0crwdne2915892:0
Often times our headphone wires, or other wires, can be completely severed. This guide is here to show you that this does not mean the device is now useless. I am going to show you how to expose your wires, and reattach them to themselves so that the current can continue to flow and the headphones can work again.
crwdns2942213:0crwdne2942213:0
-
-
If your wire is severed, the first step is removing the rubber coating to expose both ends of the severed wire.
-
Do this by wedging it in a sharp crevice and pulling at the rubber coating. It should strip just the rubber coating. The small wedge in a spudger should suffice.
-
-
-
Now that the internal wires have been exposed, take one end and group all similarly colored wires together.
-
Do the same for the other severed wire.
-
-
-
-
Twist the green wires from both ends of the severed wire together.
-
Cover in electrical tape.
-
-
-
Do the same for all matching wires on both ends.
-
Cover completely in electrical tape.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
USF Sarasota-Manatee, Team 1-2, Stewart Winter 2015 crwdns2935289:0USF Sarasota-Manatee, Team 1-2, Stewart Winter 2015crwdne2935289:0
USFSM-STEWART-W15S1G2
crwdns2931471:04crwdne2931471:0
crwdns2935297:011crwdne2935297:0
