crwdns2931315:0crwdnd2931315:0crwdne2931315:0
crwdns2942213:0crwdne2942213:0
-
crwdns2935201:0crwdne2935201:0 crwdns2935203:0crwdne2935203:0
-
On the front of the drill, remove the three 2" flathead screws connecting the front housing to the rear housing.
-
-
crwdns2935201:0crwdne2935201:0 crwdns2935203:0crwdne2935203:0
-
Pull the front housing apart from the rear.
-
-
crwdns2935201:0crwdne2935201:0 crwdns2935203:0crwdne2935203:0
-
Use the socket wrench to remove the 0.5" length screw from the bottom of the handle.
-
-
-
crwdns2935201:0crwdne2935201:0 crwdns2935203:0crwdne2935203:0
-
Remove the two 1" flathead screws located at the top and bottom of the motor housing.
-
-
crwdns2935201:0crwdne2935201:0 crwdns2935203:0crwdne2935203:0
-
After you have placed the motor housing back into the drill during reassembly, thread the wires down to the handle using tweezers.
-
Plug the forked wire into the socket at the back of the motor housing using tweezers.
-