crwdns2894164:0crwdne2894164:0

crwdns2915892:0crwdne2915892:0

Is your motor running but the drill is not turning? Replace those gears to start providing torque to your drill bit.

crwdns2860944:0crwdne2860944:0

crwdns2860947:0crwdne2860947:0

crwdns2890040:0crwdne2890040:0

  1. On the front of the drill, remove the three 2" flathead screws connecting the front housing to the rear housing.
    • On the front of the drill, remove the three 2" flathead screws connecting the front housing to the rear housing.

  2. Pull the front housing apart from the rear. The motor and gears might fall out when you are pulling it apart.
    • Pull the front housing apart from the rear.

    • The motor and gears might fall out when you are pulling it apart.

  3. Remove gear from the divider and add the new gear. Remove gear from the divider and add the new gear.
    • Remove gear from the divider and add the new gear.

crwdns2915888:0crwdne2915888:0

To reassemble your device, follow these instructions in reverse order.

crwdns2878480:0crwdne2878480:0

Matt

crwdns2886885:010/10/2010crwdne2886885:0

365 crwdns2915208:0crwdne2915208:0

crwdns2886889:07crwdne2886889:0

crwdns2915084:0crwdne2915084:0

Cal Poly, Team 5-17, Maness Fall 2010 crwdns2886886:0Cal Poly, Team 5-17, Maness Fall 2010crwdne2886886:0

CPSU-MANESS-F10S5G17

crwdns2858115:03crwdne2858115:0

crwdns2886889:07crwdne2886889:0

crwdns2917036:00crwdne2917036:0

crwdns2917038:0crwdne2917038:0

crwdns2894754:0crwdne2894754:0:

crwdns2894766:024crwdne2894766:0 0

crwdns2894768:07crwdne2894768:0 0

crwdns2894768:030crwdne2894768:0 1

crwdns2894770:0crwdne2894770:0 1,960