crwdns2942213:0crwdne2942213:0
-
-
Remove the two screws at the back of the iron.
-
Remove the back cover piece.
-
-
-
Remove the two screws holding the white clamp to the iron.
-
Remove the two screws holding the black wires to the body of the iron.
-
-
-
-
Pull the split end of the power cord upward through the ball joint of the iron.
-
Set aside power cord.
-
-
-
Remove remaining screws that hold a wire on the bottom (brown and blue).
-
Unscrew from left to right.
-
Unclip the black adapter piece on the bottom right.
-
-
-
Remove two screws (left and right) affixed to circuit board.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:03crwdne2935229:0
crwdns2947412:03crwdne2947412:0
i am trying to replace the thermal cutoff but can’s remember the wire inside how to replace
I have a constant leak in the vertical position - long after the iron is cold. The repair presented is well done. However it stopped short and doesn't get to the reservoir - thanks
Then WHAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAT?
That #0 Phillips screwdriver does not work on my Shark Model GI 505 steam Iron. Any other ideals on how to get the cover off. The electrical cord is bad and I need to put a new cord on it. Thanks in advance.
brucetaylor - crwdns2934203:0crwdne2934203:0