crwdns2942213:0crwdne2942213:0
-
-
Remove the two screws at the back of the iron.
-
Remove the back cover piece.
-
-
-
Remove the two screws holding the white clamp to the iron.
-
Remove the two screws holding the black wires to the body of the iron.
-
-
-
-
Pull the split end of the power cord upward through the ball joint of the iron.
-
Set aside power cord.
-
-
-
Remove remaining screws that hold a wire on the bottom (brown and blue).
-
Unscrew from left to right.
-
Unclip the black adapter piece on the bottom right.
-
-
-
Remove two screws (left and right) affixed to circuit board.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:03crwdne2935229:0
crwdns2915084:0crwdne2915084:0
USF Tampa, Team S1-G4, Leahy Fall 2017 crwdns2935289:0USF Tampa, Team S1-G4, Leahy Fall 2017crwdne2935289:0
USFT-LEAHY-F17S1G4
crwdns2931471:03crwdne2931471:0
crwdns2935297:010crwdne2935297:0
crwdns2944067:03crwdne2944067:0
i am trying to replace the thermal cutoff but can’s remember the wire inside how to replace
I have a constant leak in the vertical position - long after the iron is cold. The repair presented is well done. However it stopped short and doesn't get to the reservoir - thanks
Then WHAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAT?
