crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

Shark NV352 Roller Brush Replacement

crwdns2915892:0crwdne2915892:0

The roller brush helps to pick up dirt deep in the carpet or stuck to the floor. If the roller brush is no longer rotating, you may have to remove it and clean or replace it. Follow these steps to remove the roller brush.

crwdns2942213:0crwdne2942213:0

  1. Shark NV352 Roller Brush Replacement, Roller Brush: crwdns2935265:01crwdnd2935265:01crwdnd2935265:02crwdne2935265:0 Shark NV352 Roller Brush Replacement, Roller Brush: crwdns2935265:01crwdnd2935265:02crwdnd2935265:02crwdne2935265:0

    • Lift the latches on both sides of the vacuum to release the dust canister.

    • Remove the dust canister from the vacuum by lifting it up.

    crwdns2913378:0crwdne2913378:0

  2. Shark NV352 Roller Brush Replacement: crwdns2935265:02crwdnd2935265:01crwdnd2935265:01crwdne2935265:0

    • Lay down the vacuum to access the bottom panel of the roller brush compartment.

    crwdns2913378:0crwdne2913378:0

  3. Shark NV352 Roller Brush Replacement: crwdns2935265:03crwdnd2935265:01crwdnd2935265:02crwdne2935265:0 Shark NV352 Roller Brush Replacement: crwdns2935265:03crwdnd2935265:02crwdnd2935265:02crwdne2935265:0

    • Using the metal spudger, pry the two small wheels located at the two bottom corners of the vacuum to remove them.

    crwdns2913378:0crwdne2913378:0

  5. Shark NV352 Roller Brush Replacement: crwdns2935265:04crwdnd2935265:01crwdnd2935265:02crwdne2935265:0 Shark NV352 Roller Brush Replacement: crwdns2935265:04crwdnd2935265:02crwdnd2935265:02crwdne2935265:0

    • Remove the eight 19mm Phillips #2 screws from the plastic cover.

    • Remove the two 14 mm Phillips #2 screws from the upper section of the plastic cover.

    crwdns2913378:0crwdne2913378:0

  6. Shark NV352 Roller Brush Replacement: crwdns2935265:05crwdnd2935265:01crwdnd2935265:02crwdne2935265:0 Shark NV352 Roller Brush Replacement: crwdns2935265:05crwdnd2935265:02crwdnd2935265:02crwdne2935265:0

    • You will need to apply a strong force while pulling the wheels off because they are attached very tightly.

    • Remove the wheels by pulling them out of their axles, away from the vacuum.

    crwdns2913378:0crwdne2913378:0

  7. Shark NV352 Roller Brush Replacement: crwdns2935265:06crwdnd2935265:01crwdnd2935265:02crwdne2935265:0 Shark NV352 Roller Brush Replacement: crwdns2935265:06crwdnd2935265:02crwdnd2935265:02crwdne2935265:0

    • Perform the next step slowly and carefully so the wiring connecting the motherboard to the rest of the vacuum is not broken.

    • Gently pull the grey lower part of the roller brush compartment away from the purple upper part of the compartment.

    crwdns2913378:0crwdne2913378:0

  8. Shark NV352 Roller Brush Replacement: crwdns2935265:07crwdnd2935265:01crwdnd2935265:01crwdne2935265:0

    • Lift up and then pull the roller belt off of the roller brush and the motor to remove it.

    crwdns2913378:0crwdne2913378:0

  9. Shark NV352 Roller Brush Replacement: crwdns2935265:08crwdnd2935265:01crwdnd2935265:01crwdne2935265:0

    • Take out the roller brush by lifting it out of its tray.

    crwdns2913378:0crwdne2913378:0
crwdns2915888:0crwdne2915888:0

To reassemble your device, follow these instructions in reverse order.

crwdns2935229:09crwdne2935229:0

crwdns2862417:0crwdne2862417:0

crwdns2935293:0crwdnd2935293:04crwdnd2935293:0crwdne2935293:0

Amy Moran

crwdns2935283:009/22/17crwdne2935283:0

603 crwdns2915208:0crwdne2915208:0

crwdns2935297:02crwdne2935297:0

crwdns2918514:0crwdne2918514:0: 14

crwdns2935301:011crwdne2935301:0

crwdns2915084:0crwdne2915084:0

Cal Poly, Team S18-G5, Forte Fall 2017 crwdns2935289:0Cal Poly, Team S18-G5, Forte Fall 2017crwdne2935289:0

CPSU-FORTE-F17S18G5

crwdns2931471:04crwdne2931471:0

crwdns2935297:010crwdne2935297:0

crwdns2947410:01crwdne2947410:0

FOR SOME MODELS - THE BRUSH WILL NOT OPERATE IN AN UPRIGHT POSITION.

Shark navigator 350-353 series - if you have cleaned the roller and it doesn't work, TILT THE HANDLE BACK then try.

elaina heinz - crwdns2934203:0crwdne2934203:0

crwdns2917038:0crwdne2917038:0

crwdns2936625:0crwdne2936625:0:

crwdns2936751:024crwdne2936751:0 2

crwdns2936753:07crwdne2936753:0 19

crwdns2936753:030crwdne2936753:0 60

crwdns2942667:0crwdne2942667:0 5,360