crwdns2915892:0crwdne2915892:0
This guide will show you how to remove/replace the bumper plate assembly on your Shark Matrix RV2310. This is most useful in scenarios where your vacuum's bumper assembly has been cracked or broken, leaving the sensor components underneath vulnerable.
crwdns2942213:0crwdne2942213:0
-
-
Remove the six 8 mm hex screws that are holding both pieces of the bumper plate together.
-
-
-
-
Separate both pieces of the plate from one another by pulling them apart.
-
Pull the full bumper plate assembly away from the vacuum.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.