crwdns2915892:0crwdne2915892:0
Follow this guide to replace your broken fans in your Sapphire Nitro+ RX 6800 XT SE graphics card.
This graphics card uses 3mm JIS000 screws but you can use a Phillips screw driver as an alternative.
Note: This guide also works for the entire Sapphire Nitro+ RX 6000 series with a couple exceptions:
- The RX 6650 XT, RX 6750 XT, and RX 6950 XT Pure have a different blade design but the entire replacement process is the same.
- Only the RX 6800 XT SE, RX 6900 XT SE, RX 6950 XT, and RX 6950 XT Pure supports ARGB while the rest of the series does not.
crwdns2942213:0crwdne2942213:0
-
-
Unscrew the JIS000 screw securing the fan to the graphics card
-
-
-
Lift the fan from the top and pull away from you.
-
-
-
-
Clean any dust or residue present with a Q-tip damp with alcohol.
-
-
-
Flip the fan over and notice the pins on the fan and in the graphics card fan slot:
-
Fan Pins
-
Fan slot
-
Flip the fan back over keeping the same orientation and carfully insert the fan.
-
-
-
Push the fan toward you to ensure that the pins are connected.
-
-
-
Rescrew the JIS000 screw in the top of the fan.
-
Repeat steps 1 - 5 on the remaining fans if needed.
-
After assembly, the fans and RGB will work like new!
After assembly, the fans and RGB will work like new!
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0
crwdns2915084:0crwdne2915084:0
CSU Los Angeles, Team 5-25, Kershman Fall 2023 crwdns2935289:0CSU Los Angeles, Team 5-25, Kershman Fall 2023crwdne2935289:0
CSULA-KERSHMAN-F23S5G25
crwdns2934841:01crwdne2934841:0
crwdns2935303:01crwdne2935303:0
