crwdns2942213:0crwdne2942213:0
-
-
Turn watch faced down to reveal the screws. Remove the straps by pulling on pin switches to release.
-
-
-
Use the tin metal pry tool to gently penetrate the back.
-
-
-
Use the metal pry tool as support for the opening blue pick
-
-
-
-
Gently Lift the back to reveal a connector, use a tweezer to remove it then you will have access to the back
-
-
-
Separate back fully from rest of the body
-
-
-
use tweezer to remove all 3 connectors and remove the screw
The screw here is not the same as the ones on the back. This one is a phillips head (+).
of all the screw bits I have, I don't have this one,lol
-
-
-
Use Spudger to lift panel housing from body
-
-
-
Lift off motherboard and use tweezer to lift up bettery connector from the plastic housing
-
-
-
use spudger to lift battey out of plastic housing
-
-
-
Separate battery from the plastic body, then install replacement battery
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:04crwdne2935229:0
crwdns2947412:02crwdne2947412:0
I have so benefited from this portal , I have now made my own contribution. Hope it helps someone.
Excellent guide Haven't done it yet. Where can I find the battery for this watch, also what type of screwdriver are you using for the 1st 4 screws? None of mine fit it.
