crwdns2942213:0crwdne2942213:0
-
-
Turn the device off before starting any repairs
-
-
-
Use a heat gun or similar tool to heat around the edge of the glass.
-
Use a suction cup to lift the glass up and insert a opening tool in between the glass and frame:
-
Work around the glass to loosen the adhesive securing the glass.
-
Take care when sliding the tool in front of the camera, there is also alight sensor that is hidden underneath the glass
-
-
-
-
It may be possibel to pull the adhesive strip out from the glass.
-
-
-
Carefully lift the display up from the right side to expose the cables underneath.
-
The display cable can be seen as marked in the red box.
-
Disconnect the cable and remvoe the old display.
-
Clean any remaining glass or adhesive from the frame.
-
To replace the display follow the steps in reverse order. Test the display before securing it to the frame.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:04crwdne2935229:0
