crwdns2915892:0crwdne2915892:0
The front camera is on the same side as the phone's screen and is the only camera used to Skype on the Samsung Stratosphere.
crwdns2942213:0crwdne2942213:0
-
-
Using your fingers, pry along the groove at the top of the phone.
-
Pull back on the rear casing until it comes free from the device.
-
The casing will make a cracking sound as it is removed.
-
-
-
With your fingers, pry from the bottom of the battery to loosen it.
-
Lift away to remove the battery from the phone.
-
-
-
Locate the red and white sim card located above the battery housing.
-
Remove the sim card by sliding it downwards from its slot with your fingers.
-
-
-
Remove the seven silver 3mm screws securing the rear panel using the Phillips #000 screwdriver.
-
-
-
Pry around the rear panel with a plastic opening tool to loosen it.
-
Remove the rear panel from the phone with your fingers.
-
-
-
Remove the four black 3mm screws securing the motherboard with the Phillips #000 screwdriver.
-
-
-
-
Locate the flex cable attachment at the tab with a green arrow printed on top.
-
Pry from the side the arrow is pointing with your fingers.
-
The cable will audibly snap as it is removed from its attachment.
-
Let the cable hang loosely to the side of the phone.
-
-
-
Pull the motherboard up from the side opposite the loose flex cable.
-
Lift to remove the motherboard from the device.
-
-
-
Insert a plastic opening tool into any side of the phone case to separate the keyboard from the rear panel.
-
Pry the keyboard away from the casing with the plastic opening tool.
-
-
-
Remove the 7 silver 2mm screws attaching the silver metal plate to the rear panel with the Phillips #000 Screwdriver.
-
-
-
Use the plastic opening tool to carefully loosen the golden metal plate.
-
-
-
Lift the gold plate with your fingers, repositioning it to slide through the keyboard casing underneath.
-
Carefully take off the keyboard casing with your fingers.
-
The golden metal plate should fit through the wide slot of the casing.
-
-
-
Slide the silver metal plate down and away from the to the flex cable and gold metal plate.
-
-
-
Unscrew the 4 black 3mm screws from the rear panel with the Phillips #000 Screwdriver.
-
-
-
Insert the plastic opening tool into the groove at the top of the rear panel.
-
Firmly slide the plastic opening tool all around the rear panel. The panel will audibly snap as it comes apart.
-
-
-
Lift the flex cable and position it so the part containing the metal plate can come free.
-
Pull the part containing the metal plate away from the rest of the rear panel.
-
-
-
Use tweezers to loosen the front-facing camera from the plastic casing.
-
Pull the black rectangular piece, attached to the front facing camera, away from the rear panel.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:02crwdne2935229:0
crwdns2915084:0crwdne2915084:0
Cal Poly, Team 11-32, Amido Fall 2013 crwdns2935289:0Cal Poly, Team 11-32, Amido Fall 2013crwdne2935289:0
CPSU-AMIDO-F13S11G32
crwdns2931471:04crwdne2931471:0
crwdns2935297:06crwdne2935297:0
