crwdns2942213:0crwdne2942213:0
-
-
Remove these screws from the camera using a phillips head screwdriver.
-
-
-
Lay the camera down on the table and remove the metal shell from the front.
-
-
-
Wedge a spudger/flathead screwdriver inside of the shell where the screws were to pry the shell off of the back.
-
-
-
-
Remove the shell the from the back of the camera.
-
-
-
Remove the Phillips head screw from the rear panel control board to reveal the LCD's connection to the motherboard.
-
-
-
Use a spudger to flip up the light gray lever(as shown in the photo). This will release the screen so that you may pull it out.
-
-
-
Pull the screen out of the mother board.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:05crwdne2935229:0