crwdns2942213:0crwdne2942213:0
-
-
Remove the 4 (4.7mm) philips head screws.
-
-
-
Unplug the rubber charger outlet cover.
-
-
-
Unplug the rubber headset jack cover.
-
-
-
-
Begin by inserting the pry tool near the charger jack.
-
There are 4 tabs to release.
-
Start at the bottom and slide the tool up, lifting the silver front of the phone away from the white backing.
-
Loosen the 2 side tabs before moving on to the top two.
-
See the second photo to see location of the tabs.
-
Be careful of the ribbon wires shown in second photo.
-
-
-
Once the two side tabs are free; gently pry the white backing down to release the top two tabs.
-
Hold the phone with the left hand as shown
-
Wiggle the white backplate from side to side while pulling down with the right hand.
-
Be careful of the ribbon wires shown in second photo.
-
-
-
Remove the ribbon wires connecting to the screen using the pry tool.
-
-
-
2 tabs hold the motherboard in place.
-
Release the labeled tabs with the pry tool from the location shown.
-
-
-
Separate the motherboard from the phone.
-
-
-
Solder joints are accessable to replace the microphone.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
Cal Poly, Team 3-40, Regan Winter 2011 crwdns2935289:0Cal Poly, Team 3-40, Regan Winter 2011crwdne2935289:0
CPSU-REGAN-W11S3G40
crwdns2931471:04crwdne2931471:0
crwdns2935297:022crwdne2935297:0
