crwdns2915892:0crwdne2915892:0
The Keypad may get worn or dirty as time goes by. This guide will aid in the removal of the keypad for cleaning or replacement.
crwdns2942213:0crwdne2942213:0
-
-
Slide the latch on the back of the phone up.
-
-
-
After removing the battery, remove the four small Phillips-head screws with a #0 Phillips screwdriver.
-
-
-
-
Using a thumbtack, pry the small plastic cover from the case near the base of the antenna.
-
-
-
With a #0 Phillips screwdriver remove the screw which you just uncovered.
-
-
-
Using the spudger, carefully pry the case apart starting near the charging port. Ease the case open.
-
Then disconnect the small power connector near the top of the phone.
-
-
-
Gently pry up the ribbon-type connector with the spudger.
-
-
-
Carefully pry the logic board from the case with the spudger.
-
-
-
Once the logic board has been removed, peel the keypad up.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.