crwdns2915892:0crwdne2915892:0
Evaporator cover removal prereq
crwdns2942213:0crwdne2942213:0
-
-
Unplug your refrigerator before you begin your repair.
-
-
-
Slide the freezer drawer fully open.
-
-
-
Lift and remove all the freezer bins from the drawer.
-
-
-
Use a flathead screwdriver or your fingers to press in the plastic tab near the inner end of the drawer rail.
-
While pressing the plastic tab, grasp the rail with your free hand and slide it towards you slightly to unlock the rail.
-
-
-
-
Repeat the rail unlock procedure on the other drawer rail.
-
-
-
Once both rails are unlocked, firmly pull both rails to slide them out of the refrigerator wall guides.
-
Remove the freezer drawer.
-
Push the geared torsion bar until it rests at the very end of the rails.
-
Align the drawer rails to the refrigerator wall guides.
-
Close the freezer drawer until the rails lock back in place.
-
-
-
Use a Phillips screwdriver to remove the two 18.5 mm‑long screws securing the evaporator cover to the refrigerator.
-
-
-
Lift the bottom edge of the evaporator cover away from the refrigerator to release the bottom clips.
-
Don't try to fully remove the cover. It's still connected by a few wires.
-
Shift the evaporator cover downwards to access the connectors in the top right corner of the freezer compartment.
-
-
-
Squeeze the bottom edge of the fan connector to unlock it from the freezer wall.
-
Pull and disconnect the fan connector.
-
-
-
Remove the evaporator cover.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
