crwdns2915892:0crwdne2915892:0
This guide will teach you how to replace the battery of your POWERbot. This can be done to fix your POWERbot's charge retention issues.
crwdns2942213:0crwdne2942213:0
-
-
Turn off the emergency switch located at the bottom right of the POWERbot.
-
-
-
Unscrew the two 6mm Phillips #1 screws and remove the lid, exposing the battery.
-
-
-
-
Follow the wires and find the small white box next to the battery.
-
On the side of the white box facing the battery, find the rigid tab.
-
-
-
Push the tab inwards to the white box and pull the wires up. This will release the wires from the white box, allowing you to remove the battery.
-
-
-
Remove the battery by holding the battery in place and partially righting the POWERbot so the battery falls out.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:04crwdne2935229:0