crwdns2915892:0crwdne2915892:0
In this guide you will take the following steps to replace the motherboard in the Samsung PL200.
crwdns2942213:0crwdne2942213:0
-
-
Remove the two 3mm black external scews from he camera's side using the #000 Philips Screwdriver.
-
Remove the five 3mm silver external screws from the camera's side and bottom using the #000 Philips Screwdriver
-
-
-
Use the Plastic Opening Tool and your finger to pry off and remove the external cover.
-
-
-
Remove the 3mm screw holding the circuit board using the #000 Philips Screwdriver.
-
Remove any tape on the circuit board and screen.
-
Using Tweezers, unplug the wires from the circuit board and remove it.
-
-
-
Flip the LCD screen forward and remove the two 3mm screws beneath it using the #000 Phillips Screwdriver.
-
Remove the metal brace using the Plastic Opening Tool.
-
-
-
Lift the black latch where the screen plugs into the motherboard and pull the cord to remove the screen
-
Separate the screen and the metal brace from the camera body.
-
-
-
-
Remove the front cover of the camera using your fingers and the Plastic Opening Tool.
-
-
-
Set the screen and metal brace aside
-
Open the camera's battery cover.
-
-
-
Using the #000 Phillips Screwdriver, remove the two 3mm screws holding the motherboard in place.
-
There may be tape still on the motherboard, if so, remove it.
-
-
-
Use the Tweezers to remove the tape from bottom of the camera
-
Use the Tweezers to disconnect the lens unit cord that is at the bottom of the camera from the motherboard.
-
Remove the last 3mm screw that holds the motherboard in place.
-
-
-
Use the Tweezers to unplug the small lens unit cord from the camera frame on the back side of the camera.
-
Gently lift the lens unit from the frame.
-
Separate the lens unit, motherboard, and camera.
-
-
-
Use the Tweezers to remove the small cord from motherboard.
-
Use the Tweezers to remove the first large lens unit cord from the motherboard.
-
Use the Tweezers to remove the second large lens unit cord from the motherboard.
-
-
-
Desolder the four wires from the old motherboard.
-
-
-
Last, solder on a functional motherboard at this stage and reassemble the device.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
Clemson, Team 15-7, Shirley Winter 2015 crwdns2935289:0Clemson, Team 15-7, Shirley Winter 2015crwdne2935289:0
CLEM-SHIRLEY-W15S15G7
crwdns2931471:05crwdne2931471:0
crwdns2935297:09crwdne2935297:0
