crwdns2942213:0crwdne2942213:0
-
-
Unplug your refrigerator before you begin your repair.
-
Condenser fan motor
-
Compressor motor and thermal overload device
-
Water supply valve assembly
-
-
-
Open the freezer drawer.
-
-
-
Pull out the upper freezer drawer.
-
Lift the front edge of the drawer.
-
Remove the drawer by lifting it up and out of the freezer compartment.
-
-
-
Unclip the basket hinge retainer by tilting the rear edge up and remove it from the drawer rail.
-
Release the small drawer basket and lift it up and out.
-
-
-
Lift the drawer basket out of the drawer frame and remove it.
-
-
-
Use a 3/8" socket wrench, box wrench, or open end wrench to remove the bolts securing the drawer front to the right drawer slide.
-
Repeat the process for the left drawer slide.
-
-
-
Lift the drawer front upwards to free it from the drawer slides.
-
Remove the drawer front.
-
-
-
-
Rotate the slide connector rod until you can access the retaining pin.
-
Use a pair of long nose pliers to squeeze the retaining pin shank to release it.
-
-
-
Pull the retaining pin out of the hole.
-
Slide the connecting rod to the right to free the left end of the rod.
-
Remove the rod by lifting it upward and sliding it back to the left.
-
-
-
Use a #2 Phillips driver to remove the retaining screws.
-
-
-
Pull the icemaker forward parallel to the top of the freezer.
-
Reposition the icemaker and hold it in one hand to prepare to disconnect it.
-
-
-
Grasp the icemaker connector (the one to the front) and squeeze the release tab.
-
Pull the connector out from the socket.
-
-
-
Remove the ice maker.
-
This view shows the slots that the mounting studs on the freezer top for reference when reassembling.
-
-
-
Use a #2 Phillips driver to remove the screws securing the evaporator cover.
-
-
-
Lift the evaporator cover from the bottom edge and tilt the edge toward you.
-
-
-
Reposition the evaporator cover to allow access to the connections to the right rear.
-
-
-
Disconnect the connectors by squeezing the release tab on the connector and pulling them free of the sockets.
-
-
-
Finish disconnecting the connections while supporting the cover from below.
-
-
-
Remove the evaporator cover.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
