crwdns2942213:0crwdne2942213:0
-
-
Place the laptop face-down on a stable surface.
-
Remove the nine 6.5mm Phillips #0 screws shown.
-
Use the blue opening tool to gently pry the back of the laptop off of the body.
-
-
-
Use a Phillips #0 screwdriver to remove the six 4.5mm screws holding the motherboard to the case.
-
-
-
-
Use the spudger to remove the red and black cable located above the speaker from it's connector.
-
Also using the spudger, remove the small ribbon cable located a the bottom of the motherboard, towards the middle.
-
Fold the motherboard back, using the computer hinge as the axis of rotation. The motherboard will still be attached to the case by a few wires.
-
-
-
Gently unhook the red and black wires from the plastic clips holding them to the case. This can be done with only your fingers.
-
-
-
Using the spudger, lift the speaker up and out of it's holder, as shown. The yellow plastic tape should peel off as well.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
USF Tampa, Team 2-4, Nance Fall 2016 crwdns2935289:0USF Tampa, Team 2-4, Nance Fall 2016crwdne2935289:0
USFT-NANCE-F16S2G4
crwdns2931471:04crwdne2931471:0
crwdns2935297:05crwdne2935297:0
