crwdns2942213:0crwdne2942213:0
-
-
Slide the lock towards the middle of the camera, in the same direction of the arrow.
-
-
-
Push the blue battery holder up in the direction of the arrow.
-
-
-
Pull the battery out of the battery slot.
-
-
-
Use tweezers to remove the four rubber screw covers.
-
-
-
Remove the four Phillips 2.381 mm screws on back side of camera and one Phillips 2.381 mm screw on the bottom of the camera, using a Phillips #00 screwdriver.
-
-
-
-
Remove the back casing by just carefully pulling the casing off of the camera.
-
-
-
Use the Phillips #00 screw driver to remove the four 2.381 mm screws next to the screen hinge.
-
-
-
Use plastic opening tool to disconnect screen connector from the control board.
-
-
-
Remove the 2.381 mm screw with a Phillips #00 screwdriver.
-
-
-
Use the plastic opening tool to remove the silver metal lens cover.
-
-
-
Use the tweezers to remove the black electrical tape covering the copper connector to the control board.
-
-
-
From the front of the camera, push the lens through the back of the camer.a
-
-
-
Use a pair of tweezers to flip up the black retaining bar on each of the two ZIF connectors.
-
-
-
Remove the lens assembly from the camera.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0
crwdns2915084:0crwdne2915084:0
Sam Houston State, Team 13-2, Blackburne Winter 2015 crwdns2935289:0Sam Houston State, Team 13-2, Blackburne Winter 2015crwdne2935289:0
SHSU-BLACKBURNE-W15S13G2
crwdns2931471:03crwdne2931471:0
crwdns2935297:08crwdne2935297:0
