crwdns2915892:0crwdne2915892:0
Demonstrates how to replace the front case of the camera through pictures and words. Replacement of the rear case requires disassembling battery housing and battery from front case.
crwdns2942213:0crwdne2942213:0
-
-
To remove the wristband of the device, grab the middle loop and pull the band through.
-
-
-
Remove four screws with a Hex 1.5 mm screwdriver.
-
-
-
Open the HDMI door on the side of the camera.
-
Remove the single screw using a Phillips #00 screwdriver.
-
-
-
Use the iFixit opening tool on both sides on the device. Pry apart both sections with light force.
-
-
-
-
Pull the wire ribbon out with a pair of tweezers.
-
-
-
Remove the four screws from the battery housing using a Phillips #00 screwdriver.
-
-
-
Use the iFixit opening tool to pry the battery housing open.
-
-
-
After removing the battery housing, take the battery out.
-
-
-
Use an iFixit opening tool to pry up the plastic cover.
-
Use tweezers to remove the wire from the slots.
-
-
-
Remove both screws from the USB port using a Phillips #00 screwdriver.
-
-
-
Push the USB port inside the case to remove it from the device.
-
-
-
The front case is separated from the rest of the device.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.